P2584

P2584 OBD Code Definition:
P2584 Fuel Additive Control Problem
P2584 OBD Code Description:

OBD Code P2584

Fuel Additive Control Problem

What’s mean?

OBD2 Code P2584 Definition:
The PCM monitors that the fuel additive control system operation. If the fuel additive control module detects the fuel additive control system malfunction and requests to PCM that the MIL turn ON. The PCM determines that the fuel additive control module requests the MIL to ON.

Symptoms

Possible sumptoms of P2584
DPF or Mil Light

Possible Causes

Possible causes of P2584
? Fuel additive system malfunction ? Fuel additive level sensor malfunction ? Fuel additive control module malfunction

Possible Solutions

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
???Has the FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY REPAIR INFORMATION AVAILABILITY
???Verify related service repair information availability.
???Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA
???Is P2584 on FREEZE FRAME DATA?
Yes
Go to the applicable DTC inspection.
No
Go to the next step.
4
INSPECT FUEL FILLER CAP SWITCH
???Inspect the fuel filler cap switch.
???Is the fuel filler cap switch normal?
Yes
Go to the next step.
No
Replace the fuel filler cap switch, then go to Step 6.
5
INSPECT FUEL ADDITIVE LEVEL SENSOR
???Inspect the fuel additive level sensor.
???Is the fuel additive level sensor normal?
Yes
Go to the next step.
No
Replace the fuel additive level sensor, then go to Step 7.
6
IDENTIFY MALFUNCTION AT FUEL ADDITIVE CONTROL MODULE OR NOT
???Make sure to reconnect all disconnected connectors.
???Clear the DTC from the PCM memory using the M-MDS.
???Start the engine and warm-up to normal operating temperature.
???Run the vehicle under the FREEZE FRAME DATA stored condition.
???Retrieve the DTC using the M-MDS.
???Is the PENDING CODE same DTC present?
Yes
Inspect and repair or replace the fuel additive pump, then go to the next step.
No
Replace fuel additive control module, then go to the next step.
7
VERIFY THAT DTC P2584 TROUBLESHOOTING IS COMPLETED
???Make sure to reconnect all disconnected connectors.
???Clear the DTC from the PCM memory using the M-MDS.
???Start the engine and warm-up to normal operating temperature.
???Run the vehicle under the FREEZE FRAME DATA stored condition.
???Retrieve the DTC using the M-MDS.
???Is the PENDING CODE same DTC present?
Yes
Replace PCM, then go to the next step.
No
Go to the next step.
8
VERIFY AFTER REPAIR PROCEDURE
???Perform “After Repair Procedure”.
???Is there any DTC present?
Yes
Go to the applicable DTC inspection.
No
Troubleshooting completed.

OBD-II Codes

P2585 P2586

OBD Code P2584

Fuel additive control module MIL request

Leave a Reply

Your email address will not be published.