P0330

P0330 OBD Code Definition:
P0330 Knock Sensor 1 Circuit Bank 2 Or Single Cylinder
P0330 OBD Code Description:

OBD Code P0330

Knock Sensor 2 Circuit

What’s mean?

OBD2 Code P0330 Definition:
A knock sensor tells the engine computer when one or more of your engine’s cylinders are “knocking”, that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged. The computer uses this information to tune the engine so that it doesn’t knock. If your knock sensor wasn’t operating properly, so that it was always indicating a knock, the engine computer’s response may have been to change the ignition timing on your engine. Knock sensors generally bolt into or thread into the engine block. This P0330 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0325.

Symptoms

Possible sumptoms of P0330
You may notice drivability problems including a lack of power and perhaps some hesitation. There may also be other symptoms.

Possible Causes

Possible causes of P0330
A code P0330 most likely means one or more of the following has happened: The “B” knock sensor is faulty and needs to be replaced There is a wiring short/fault in the knock sensor circuit

Possible Solutions

Check the resistance of the knock sensor on bank 2 (compare it to factory specs) Check for broken/frayed wires leading to the sensor Replace the knock sensor on bank 2

Leave a Reply

Your email address will not be published.