P0233

P0233 OBD Code Definition:
P0233 Throttle Position Sensor 2 Circuit Low
P0233 OBD Code Description:

OBD Code P0233

Fuel Pump Secondary Circuit Intermittent

What’s mean?

OBD2 Code P0233 Definition:
The powertrain control module (PCM) provides ignition positive voltage to the coil side of the fuel pump relay. When the ignition switch is first turned ON, the PCM energizes the fuel pump relay, which applies power to the fuel pump. The PCM enables the fuel pump relay as long as the engine is cranking or running, and crankshaft reference pulses are received. If no crankshaft reference pulses are received, the PCM de-energizes the fuel pump relay after 2 seconds. The PCM monitors the voltage on the fuel pump relay control circuit.

Symptoms

Possible sumptoms of P0233
– Engine Light ON (or Service Engine Soon Warning Light)

Possible Causes

Possible causes of P0233
– Open Inertia Switch – Blown Fuel Pump fuse – Open Fuel Pump Monitor Circuit – Open Fuel Pump Control Circuit – Faulty Fuel Pump Relay – Damaged PCM. The Error code is generally activated on detection of the following conditions: The code will be set if an intermittent voltage on the control circuit of the fuel pump relay is detected by the PCM.

Possible Solutions

For some models: 1. Disconnect the inertia switch harness connector. 2. Turn key to ON position (Engine OFF) 3. Measure voltage of circuit between inertia switch harness connector and ground. 4. If battery voltage is found, replaced Inertia Switch. 5. Clear codes.

Leave a Reply

Your email address will not be published.